The pneumatic screwdriver is easy to break

People who have not used pneumatic screwdrivers generally have this question. However, this question is vague. Take the production workshop as an example, and answer it systematically from the overall perspective.

1. For pneumatic screwdrivers used for assembly of assembly lines, tools should be evaluated and purchased according to their own output. For example, what specifications of screws are used in the product? M3 or M4 or others? (This refers to the diameter of the screw thread). Because it is planned now, we can only make a rough estimate. When a station Z is fast, how many screws of a certain specification can be driven for one day? This is the workload. The workload of 2000 pieces/day is different from that of 5000 pieces/day. Therefore, different pneumatic screwdrivers should be selected for different workloads. The greater the workload, the better and more stable pneumatic screwdrivers should be purchased for use, so that the tools are not prone to failure, and the duration and product quality will not be affected by the tools. We need to find a professional business as a consultant.

Purchase the appropriate pneumatic screwdriver according to the screw capacity and workload, and pay attention to maintenance at ordinary times. The tools are not easy to break. On the contrary, if you buy it at random, a pneumatic screwdriver can be used at all stations. Some of the screws are too big to be used. If you don't pay attention to maintenance at ordinary times, the tools will naturally break down;

2. Because it is an assembly line, it is recommended to find a professional supplier to do the air pipe wiring. The professional supplier will estimate the air consumption and select the appropriate air compressor according to the number of pneumatic tools you need, as well as the size, pressure stabilization, water filtering, etc. of the line pipe to be used, and design and construct according to these conditions.

Er~If it is only a small scale, my suggestion is: the air compressor room should be as close to the workshop as possible; The workshop should find a suitable place to place the air storage tank with larger capacity; All stations shall be equipped with triplets (for pressure stabilization, water filtering and automatic refueling); The main air pipe should be larger, because it is high pressure compressed air, you should buy a good pipe; The station wiring is of loop type (loop type, multi pipe connection), and it is forbidden to use only one pipe to the bottom, which may cause sufficient torsion of the station air pressure near the air receiver, and the more it goes to the end of the line, the less force it will have, and the screws of the rear station will also be unqualified if they are screwed to the product. (Make up your brain. If you open the water tap at the same time, the water potential near the main pipe will be stronger, and there will be no flow behind?)

3. After using the pneumatic screwdriver for a period of time, there must be some consumables that need to be replaced. Therefore, it is recommended that you find a professional supplier to purchase, so that there will be better service before and after sales.